Finally, Infrared Heaters That Actually Fit
Let’s be honest: swapping out heating lamps in a PET blowing line is usually a pain. You’re either fighting with footprints that don’t quite line up or staring at a wiring mess that makes you want to walk away. We got tired of that. So, we built our infrared heaters to just work. Whether you’re running an old-school SBO machine, a newer Matrix series, or anything in the Sidel lineup, these just slide right in. The secret is in the fit. If a quartz tube is a fraction too tight, the glass stresses and pops. Too loose? You’re losing heat and wasting energy. We obsess over the length and diameter so they slide into your reflectors without any forcing. It’s a smooth fit. Every time. And the wiring? No adapters. No splicing. No headaches. We stuck with the standard R7s and Sk15 connectors, so you can just plug them into the loom you already have. Getting the heat right. We use shortwave infrared tech because it hits those PET preforms fast. But we don’t just throw wattage at the problem. We calibrate the power to match your specific machine. Here is a quick tip: if you’re using our high-wattage tubes to speed up your cycle times,**check your cooling blowers.**If they’re clogged with dust, the oven housing can overheat. Keep it clean, and the lamps will do their job. Swap them and get back to work. The best part is the lack of “fiddling.” You pull the old lamp, slide ours in, lock the connector, and you’re done. No modifications, no “near-fits,” and way less downtime. We also added a special coating to the quartz. It spreads the heat more evenly, which stops those annoying hot spots that leave your bottles looking pearlescent or cloudy. Just one thing—keep the glass clean. Oil or dust buildup is the enemy here; it’ll kill a tube way faster than it should. Keep them spotless, and they’ll last.